|
christopher2021
Angemeldet seit:
01.07.2021
Beiträge: 5802
|
In daily inspection of special equipment inspection work, often come into contact with double girder overhead *****. Crane brake device configuration is in line with the actual relationship to the service life of equipment and the use of security. Therefore, it is necessary for the ***** brake device configuration are discussed. Standard series of braking device commonly used cranes include hydraulic block brake,electromagnetic block brake, disc brake, band brake, etc., its use to consider general type, specification, and check calculation, also want to consider using the environment and related factors.
crane-brake-system.jpg
Crane Brake of *****
Crane brake of double girder crane type choice, mainly according to the requirements of the lift machine or agency product standards and actual needs, determine the type of brake. As standard: lifting mechanism, luffing mechanism must be set close-type brake, often walk or slewing mechanism can choose often close-type brake. Consider using places, such as brake installation has enough space, can choose to block, band brake or arm type disc brake; Space limit, can choose the shoes or clip-on disc brake.
Consider supporting the use of the host environment, the leakage of oil have strict requirements of occasions should choose electromagnetic or pneumatic brake, the environmental temperature high metallurgical places can choose insulation class higher power hydraulic brake or metallurgical type electromagnetic brake. In the environmental temperature is lower or higher, when choosing electric hydraulic brake and open spaces, replace the corresponding brand of hydraulic oil should be paid attention to. In the iron filings and dust serious environment, should avoid to use electromagnet brake, prevent dust from entering the electromagnet gap influence electromagnet suction. For special or important occasions, should according to the need to add additional function of the brake. In low temperature environment, can use electric heater of hydraulic driver. For conversion start and brake process has strict requirements, equipped with state of the switch in order to understand the opening of the brake. For environment maintenance, adjustment more difficult to implement, can be mounted to the equality of device and friction wear brake clearance self-compensation device. Add manually loose brake device can under special circumstances artificial open the brake.
crane-brake-of-double-girder-crane.jpg
Crane Brake of *****
In order to alleviate brake wear, reduce impact and vibration because of the brake too hard, brake and brake control and recommended support. Crane brake of double girder crane is commonly electric braking control, such as regenerative braking, reverse connect braking, energy consumption braking and eddy current brake, etc. Electric braking is used only for kinetic energy consumption, make the organization safety deceleration. And electric braking use meantime, in support of brake minimum safety factor should be meet the provisions of the original alone. Also can use the secondary braking to reduce wear and impact, brake used in kinetic energy consumption for the first time, make the mechanical safety to slow down and stop, the second brake to ensure support security, such as for wind brake.
The standard provisions of the state: to hook crane, when lifting mechanism work level equal to or higher than the M4 and rated lifting speed is equal to or higher than 5 m/min, the electric braking method should be adopted, guarantee (0.2 1.0) times the rated lifting weight falls within the scope of the load, brake motor droop to synchronous speed before 1.3 below. Conventional standard brake work environment cannot have inflammable, explosive and corrosive gas, such as the relevant provisions of the environmental conditions beyond, should choose the explosion-proof type brake.
crane-brake-of-overhead-crane.jpg
Crane Brake Used for Lifting Part of Double Girder Crane
Crane brake of double girder crane specification was determined, in order to ensure brake can effectively work or support load, and avoid the impact of braking distance is too long or brake too hard, the workers should check the brake average deceleration, braking time and braking distance.
Equipment used in different working condition, the relevant standards to the appropriate agency of average deceleration, braking time and braking distance are made clear rules. For the vertical brake of the brake and the brake in frequent use in high temperature environment should be heat calculation, a brake inspection under the maximum allowable temperature send out quantity of heat is greater than the heat generated by the braking process, in order to avoid friction surface overheating damage or failure.
*****
|
